Difference between revisions of "Czech"

Revision as of 07:43, 4 August 2023

Czech
MCC Prefix	230
Coordinators	OK1MX,
Website	http://www.hamradio.cz/

Czech & Slovak = BM2302

08/2023 - Testovani transcoding / konverze mezi D-STAR, DMR a YAESU FUSION! Od 2.tydne v Srpnu roku 2023 pobezi na reflectorech XLX019,XLX230 a XLXCZE testovaci provoz pro transkodovani mezi tremi druhy digitalnich provozu. Bude nutne nekolikrat system nastavovat, restartovat, menit "jitter buffer" apod. Omlouvame se tedy za mozne vypadky ci spozdeni.

PS: Dekujeme Janovi OM6AXE za darovani hardware pro transcoding! (Neni to levna zalezitost).

Provizorni info: 1 x AMBE3003 1 x AMBE3000

Transcoding duplex mezi: TG230 TG231 TG2300 a jejich ekvivalenty v D-STAR siti. Pro YSF neni nutny transcoding, bezi-li vse na modu [DN] (VW - Wide pouziva dvojnasobny bitrate a je nutne ho jiz konvertovat, tudiz rezim VW ztraci pri prechodu do DMR ci DSTAR sve vyhody)

Please note that GPS 5057 DOES NOT WORK ANYMORE!!! POZOR!!! GPS 5057 DESTINACE UKONCENA!!!

Info

SYSOPs: OK1MX,OK2IT,OK1ALX,OK1MAB,OK7RB

WorldWide Dashboard

Czech Dashboard

Slovak Dashboard

All hams are welcome from all over the world works without any limitations.

Worldwide Talk Groups

The talk groups that are available worldwide and based on the spoken language and geographic area. These talk groups may be configured as Dynamic Talk Groups in your area which are contacted by a PTT press on a group contact number. After the PTT press, the repeater transmits activity on this talk group for 10 minutes after last PTT press.

National Static Talk Group

These talk groups may be configured as Static Talk Group, it is a national wide

Reflectors

Attention! Reflectors are now Deprecated

Use the appropriate TalkGroup

Following talk groups may be configured as Dynamic Talk Groups with respect to listed reflectors worldwide.These are activated by a PTT press on a relevant group number. After initial PTT press repeater then transmits activity on this talk group for 10 minutes since last activity of the group / reflector or local PTT press.

Dynamic Talk Groups and Reflector management using DMR Terminal (TRX)

Apart from static Talk Groups(TG), dynamic TG will be created upon transmitting on this TG for first time, TG will be created on same timeslot(TS) it has been initiated. Dynamic TG will state active for either 10 minutes after last transmission has been made or received on this particular TG or it can be deleted / removed by transmitting on TG4000 on respective timeslot. As of December the server will now respond "Not Linked" on either Time Slot, previously only on Time Slot 2.

So to sum this up -

                              TG4000: =  all dynamic Talk Groups disconnection

On HotSpots (DV-MEGA, OpenSPOT,MMDVM) where there is a single TimeSlot (TS2), the same applies - TG4000 disconnects all

Local Repeater usage of connect between two repeaters

- Each repeater has its own TG-230xxx = ID. For local use, set the TG of repeaters.

- If you want Your call only to one of the other repeaters, set its ID as the TG.

MMDVM.ini

This is the way to configure MMDVM.ini to give access to the National BrandMeister.

Applications

Regions for WX Warning

Rozdělení krajů na TG: